Tow-starting, towing away – Mini 2010 Cooper Convertible User Manual
Page 139
137
There must not be any contact between
the bodies of the two vehicles; otherwise,
there is a danger of shorting.
<
Connecting jumper cables
Connect the jumper cables in the correct
order, so that no sparks which could cause
injury occur.
<
1.
Open the battery cover in the engine com-
partment to access the positive terminal of
your MINI.
2.
Release the tabs of the positive terminal
cover
*
on the left and right, arrows 1, and
lift the cover to open, arrow 2.
3.
Attach one terminal clamp of the plus/+
jumper cable to the positive terminal of the
battery or to a starting-aid terminal of the
vehicle providing assistance.
4.
Attach the second terminal clamp of the
plus/+ jumper cable to the positive terminal
of the battery or a starting-aid terminal of
the vehicle to be started.
5.
Attach one terminal clamp of the minus/–
jumper cable to the negative terminal of the
battery or to an engine or body ground of
the assisting vehicle.
Body ground in MINI:
6.
Attach the second terminal clamp of the
minus/– jumper cable to the negative termi-
nal of the battery or to the engine or body
ground of the vehicle to be started.
Starting the engine
1.
Start the engine of the donor vehicle and
allow it to run for a few minutes at slightly
increased idle speed.
2.
Start the engine of the other vehicle in the
usual manner.
If the first start attempt is not successful,
wait a few minutes before another attempt
in order to allow the discharged battery to
recharge.
3.
Let the engines run for a few minutes.
4.
Disconnect the jumper cables by reversing
the above connecting sequence.
If necessary, have the battery checked and
recharged.
Never use spray fluids to start the
engine.
<
Tow-starting, towing
away
Observe the applicable laws and regula-
tions for tow-starting and towing vehi-
cles.
<
Do not transport any passengers other
than the driver in a vehicle that is being
towed.
<
Online Edition for Part no. 01 41 2 604 483 - © 02/10 BMW AG