Altera ByteBlasterMV User Manual
Page 16
1–8
Altera Corporation
Installation
cd byteblaster
r
3.
Run the configure install script by typing the following command at the
command prompt:
./configure
r
4.
Compile the Altera ByteBlaster kernel driver by typing the following
command at the command prompt:
make
r
5.
Become root and compile the Altera ByteBlaster kernel driver module and
device nodes by typing the following command at the command prompt:
make install
r
Installing the ByteBlasterMV Download Cable on a Linux
Workstation
To install and set up the ByteBlasterMV download cable on a Linux workstation
for device configuration or programming, follow these steps:
1.
Attach the ByteBlasterMV download cable to a parallel port on your Linux
workstation and insert the 10-pin female plug into the prototype system
containing the target device, as shown in
.
1
The board must supply power to the ByteBlasterMV download
cable.