Saab 2000 9-5 - Manual (Page 158)

158 Starting and driving
Towing the car Front towing eye
The front towing eye is stored with the spare
wheel.
The attachment point (tapped hole) for the
towing eye is midway along the engine sub-
frame at the front of the car.
Remove the plastic plug and screw in the
towing eye securely.
To ensure that the towing eye is in far
enough, insert the handle of the wheel
wrench through the eye for additional lever-
age.
WARNING
• Remember that the brake servo does
not operate when the engine is off.
Much greater pressure than normal
will therefore be required to operate
the brake pedal.
• Nor does the steering servo operate
when the engine is off. The steering
will therefore be much heavier than
usual.
• The towing vehicle should always be
heavier than the vehicle on tow.
• Never allow passengers to ride in the
car being towed.
WARNING
• Make sure that the towing eye at the
front is screwed in tightly.
• The towing eye is only designed for
use when the car is being towed on the
road. It must not be used to pull the
car out of a ditch, for example. If the
towing eye were to shear suddenly, it
could cause serious injury.
• Always seek professional help if the
car needs to be recovered.
NOTE
• Do not drive the car with the front
towing eye in position. If it catches the
curb, for example, the engine sub-
frame could be damaged.
• Refit the plastic plug in the hole when
the towing eye has been removed, to
keep dirt out of the thread
s .
IB482
Front towing eye