Mercedes-Benz 2013 CLA Class - Manual (Page 223)

X Press the : or 9 button to select the
Daytime driving lights function.
If the Daytime driving lights function
has been switched on, the cone of light and
the W symbol in the multifunction dis-
play are shown in red.
X Press the a button to save the setting.
Further information on daytime driving lights
(
Y page 107).
Switching the Intelligent Light System
on/off
X Press the = or ; button on the steer-
ing wheel to select the
Settings menu.
X Press the : or 9 button to select the
Light submenu.
X Press a to confirm.
X Press the : or 9 button to select the
Intell. Light System function.
If the Intell. Light System function has
been switched on, the cone of light and the
L symbol in the multifunction display
are shown in red.
X Press the a button to save the setting.
If you activate the Intell. Light System
function, you activate the following functions:
R
Motorway mode
R
Active light function
R
Cornering light function
R
Extended range foglamps
If you set the dipped-beam headlamps for
driving on the right/left (
Y page 221), the
multifunction display shows the Intell.
Light System: System inoperative
Inactive for left-side traffic or
Intell. Light System: System inoper‐
ative Inactive for right-side traf‐
fic display message instead of the Intell.
Light System: function in the Light sub-
menu.
Further information on the Intelligent Light
System (
Y page 110).
Setting the dipped-beam headlamps for
driving on the left/right
X Press the = or ; button on the steer-
ing wheel to select the
Settings menu.
X Press the : or 9 button to select the
Light submenu.
X Press a to confirm.
X Press : or 9 to select the Dipped
beams Setting for: function.
You will see the selected setting: Right-
side traffic or Left-side traffic .
X Press the a button to save the setting.
If you change the setting, conversion does
not take place until the next time the vehi-
cle is stationary.
This function is only available on vehicles with
the Intelligent Light System.
You can use this function to switch between
symmetrical and asymmetrical dipped beam
(
Y page 106).
If you set the dipped-beam headlamps for
driving on the left/right, then motorway
mode and the extended range foglamps are
unavailable.
You can also have the dipped-beam head-
lamps set for driving on the right/left at a
qualified specialist workshop, e.g. a
Mercedes-Benz Service Centre.
Switching Adaptive Highbeam Assist on/
off
X Press the = or ; button on the steer-
ing wheel to select the
Settings menu.
X Press the : or 9 button to select the
Light submenu.
X Press a to confirm.
X Press the : or 9 button to select the
Adapt. main beam function.
If the Adapt. main beam function has
been switched on, the cone of light and the
_ symbol in the upper multifunction
display are shown in red.
X Press the a button to save the setting.
Menus and submenus
221
On-board computer and displays
Z