Homelink, Universal transceiver (if so equipped) -57, Programming homelink – NISSAN 2008 Titan User Manual

Page 137

Advertising
background image

The HomeLink

ா Universal Transceiver provides a

convenient way to consolidate the functions of up

to three individual hand-held transmitters into

one built-in device.
HomeLink

ா Universal Transceiver:

● Will operate most Radio Frequency (RF)

devices such as garage doors, gates, home

and office lighting, entry door locks and se-

curity systems.

● Is powered by your vehicle’s battery. No

separate batteries are required. If the vehi-

cle’s battery is discharged or is discon-

nected, HomeLink

ா will retain all program-

ming.

Once the HomeLink

Universal Transceiver

is programmed, retain the original trans-
mitter for future programming procedures
(Example: new vehicle purchases). Upon
sale of the vehicle, the programmed
HomeLink

Universal Transceiver buttons

should be erased for security purposes. For
additional information refer to “Program-
ming HomeLink

” later in this section.

WARNING

Do not use the HomeLinkUniversal

Transceiver with any garage door

opener that lacks safety stop and re-

verse features as required by federal

safety standards. (These standards be-

came effective for opener models

manufactured after April 1, 1982). A ga-

rage door opener which cannot detect

an object in the path of a closing garage

door and then automatically stop and

reverse, does not meet current federal

safety standards. Using a garage door

opener without these features in-

creases the risk of serious injury or

death.

During the programming procedure

your garage door or security gate will

open and close (if the transmitter is

within range). Make sure that people or

objects are clear of the garage door,

gate, etc. that you are programming.

Your vehicle’s engine should be turned

off while programming the HomeLink

Universal Transceiver.

PROGRAMMING HOMELINK

1. To begin, press and hold the two outer

HomeLink

ா buttons (to clear the memory)

until the indicator light

1

blinks (after 20

seconds). Release both buttons.

2. Position the end of the hand-held transmitter

1 - 3 inches (26 - 76 mm) away from the

HomeLink

ா surface.

WIC0986

HOMELINK

UNIVERSAL

TRANSCEIVER (if so equipped)

Instruments and controls

2-57

REVIEW COPY—

2008 Titan (tzw)

Owners Manual—USA_English (nna)
10/11/07—debbie

Advertising