NISSAN 2008 Titan - Manual (Page 246)

“Setup”
Main Menu
“Setup”
“Pair Phone”
᭺
A
“List Phone”
᭺
B
“Select Phone”
᭺
C
“Change Priority”
᭺
D
“Delete Phone”
᭺
E
“Bluetooth Off”
᭺
F
Use the Setup command to change options as-
sociated with the Bluetooth ா Hands-Free Phone
System.
“Pair phone”
᭺
A
Use the Pair Phone command to pair a phone to
the Bluetooth ா Hands-Free Phone System.
NOTE:
The pairing procedure must be performed
when the vehicle is stationary. If the vehicle
starts moving during the procedure, the
procedure will be cancelled. Also, see
“Pairing procedure” earlier in this section
for additional information.
Up to 5 phones can be paired. If you try to pair a
sixth phone, the system announces that you must
first delete one phone or replace an existing
phone.
If you try to pair a phone that has already been
paired to your vehicle’s system, the system an-
nounces the name the phone is already using.
The pairing procedure will then be cancelled.
When prompted by the system, choose from the
following commands:
● “New phone” — Refer to “Pairing a phone”
earlier in this section.
● “Replace phone” — The system announces
the names of the phones already paired and
asks which you would like to replace.
Once you say the name of the phone you
wish to replace, the pairing procedure will
begin. Refer to “Pairing procedure” earlier in
this section.
● “List phone” – See the description below.
“List phone”
᭺
B
Use the List Phone command to hear the names
of the phones currently paired. If no phones are
paired, the system announces, “No paired
phones to list.” The system then ends the VR
session.
“Select phone”
᭺
C
Use the Select Phone command to select a
phone of lesser priority when two or more phones
paired with Bluetooth ா Hands-Free Phone Sys-
tem are in the vehicle at the same time.
The system asks you to name the phone and
confirm the selection.
Once the selection is confirmed, the selected
phone remains active until the ignition switch is
turned OFF or you select a new phone.
“Change priority”
᭺
D
Use the Change Priority command to change the
priority level of the active phone.
The priority level determines which phone is ac-
tive when more than one paired Bluetooth ா
phone is in the vehicle.
The system states the priority level of the active
phone and asks for a new priority level (1, 2, 3, 4,
5).
If the new priority level is already being used for
another phone, the two phones will swap priority
levels.
For example, if the current priority levels are:
Priority Level 1 = Phone A
Priority Level 2 = Phone B
Priority Level 3 = Phone C
4-82 Display screen, heater, air conditioner, audio and phone systems
੬
REVIEW COPY— 2008 Titan (tzw)
Owners Manual—USA_English (nna)
10/12/07—debbie
੭