Optoma WHD200 - Manual (Page 16)

16
Step 4: Boot up the Transmitter and
Receiver
(1) Place the two AAA batteries into the
remote control.
(2) After the power cord is plugged into the
electrical outlet, the WHD200 will be turned on automatically.
(3) If it is in Standby mode (Both POWER LED of transmitter and receiver are lit in red), press the
POWER button either transmitter or receiver to turn on the transmitter and the receiver. Same
condition for remote control operation.
(4) If transmitter’s HDMI out display is on (Transmitter POWER LED is lit in purple) and receiver
stay in Standby mode (Receiver POWER LED is lit in red), press the POWER button of receiver or
transmitter to wake up system and will make wireless connection automatically between
transmitter and the receiver.