Optoma WHD200 - Manual (Page 19)

19
Note:
A. If the RF connection over 80sec and still not established, it might link lost or the transmitter is
most likely out of range. You may have to verify the range and adjust or shorten the distance
between your HDTV set with the transmitter and the receiver. The maximum video
transmission range for 1080p content is up to 66 feet in line of sight (LOS). < The minimum
range is 6.5 feet. >
B. Please make sure the computer have been power on and switched the signal output to HDMI
out; also try to re-plug the HDMI cable to make sure the HDMI connector had settled well.
C. If there is no video displayed and OSD displayed “Not Supported Format”, this is an indication
that the video frame rate from the computer is not supported, please refer chapter 5 to switch
a supported video timing.
D. If you have more than one pair of WHD200, each transmitter and receiver should be at least
6.5 feet away from one another. If both the transmitter and the receiver exist in the same room,
the suggested the distance between the two is 6.5 feet minimum.
(9) On Screen Display (OSD) vs. RCU Instruction
 On Active mode, Press the POWER button on the top of Receiver or press RCU Power button
point to receiver, receiver enter Standby mode and transmitter’s HDMI out is on.
OSD Displayed: (Display 3secs and then enter Standby mode.)
ON
 On Active mode, Press the POWER button on the top of Transmitter or press RCU Power button
point to transmitter, both transmitter and receiver will enter Standby mode.
OSD Displayed: (Display 3secs and then enter Standby mode.)
OFF
 Press the INFO button on the RCU, and Signal Quality, Source, Channel and resolution will be
displayed for user reference.
OSD Displayed: (Press again for exit.)
HDMI1 CH10 1280x1024
= OFF