Casella CEL CEL24X - Manual (Page 9)

Figure 5 Calibration Mode Screen
5. Press left key (A) to perform a calibration, or press the right key (B) to
Exit. When calibration is complete, the Calibration Complete screen will be
displayed (Refer to Figure 6).
Figure 6 Calibration Complete Screen
Back to Index
6. INSTRUMENT SETTINGS
1. The Instrument Settings can be changed from the Measurement screen (Refer to
Figure 7).
2. Press and release the Left key (A). An Arrow (X) will be displayed beside the
Settings key indicating the Settings Menu has been enabled. Note that the reset
symbol
will be replaced by the relevant settings to be changed as described
below.
3. Press and release the Left key (A) repeatedly to cycle through the Settings
screens. Note that the screens displayed will be dependent on which CEL-200
series model purchased.
9