Standby mode display – CIRCUTOR CEM-C10 series User Manual
Page 14
4.4.-
DISPLAY MODES
The
CEM-C10 has 2 display modes:
Standby mode display
Reading mode display
4�4�1� STANDBY MODE DISPLAY
With the display in standby mode, all of the information is presented in cyclic form without any
need to perform any action on the
CEM-C10 keyboard.
Six different parameters are viewed in this mode, see
, in which they alternate every 6
seconds.
The unit is in this mode by default when none of the keys are pressed.
Short press the
key to stop the cyclic movement of the parameter being shown at the time.
From then on, short press the
key to browse all the parameters defined in
.
Table 6: Standby mode displays
Screen
Parameters
Total imported active energy
Total exported active energy
Only displayed in the 4-quadrant version.
Reactive energy quadrant L+ total
(1)
Reactive energy quadrant L- total
(1)
Only displayed in the 4-quadrant version.
Reactive energy quadrant C- total
(1)
Only displayed in the 4-quadrant version.
14
CEM-C10
Instruction Manual