Dometic DM2862 - Manual (Page 17)

- 17 -
Before starting the refrigerator:
Check that all the manual gas valves are in the ON position. •
Make sure that a continuous 12V DC supply is available for •
the electronic control to function.
To start the refrigerator:
Press the ON/OFF button. 1.
Select operation mode: 2.
AUTO - AeS/AUTO mode •
AC and GAS.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button (if not already on). The illuminated
lamp indicates the selected mode.
(If the CHECK indicator lamp is illuminated, see
rEFrIGErATOr OvErvIEw > MODES OF
OPErATION > AUTO MODE - AES/AUTO MODE
for
further information.)
GAS mode •
GAS operation only.
Press the AUTO/GAS - AES/AUTO/GAS mode
selector button to turn off the AUTO mode (if not
already off).
(within 45 seconds the burner should be ignited
and operating normally. If not, see
rEFrIGErATOr
OvErvIEw > MODES OF OPErATION > GAS MODE
for further information.)
DC mode • (3-way models only)
Press the DC mode indicator button. The DC lamp
will be turned on. To select AUTo or GAS mode,
turn off the DC mode by pressing the DC mode se-
lector button. The DC lamp will then be turned off.
If necessary, adjust the thermostat by pressing the 3.
Temperature selector button.
( RM2351, RM2451, RM2551, DM2652 &
DM2852 : The temperature is controlled by a factory
preset temperature setting.)
turning on the CliMate Control
DM2652, DM2662, DM2663, DM2852, DM2862, NDM1062 &
NDR1292
Turn the Climate control switch to I (ON).
DM3862, NDM1062 & NDR1292
Press the CLC button. The indicator lamp will
illuminate.
turning on the low aMbient Control
NDM1062 & NDR1292
Turn the Low ambient control switch to I (ON).
DM3862, NDM1062 & NDR1292
Press the LAC button. The indicator lamp will
illuminate.
turning off the refrigerator
The refrigerator may be shut off while in any mode of opera-
tion by pressing the main power ON/OFF button to the OFF
position. This shuts off all DC power to the refrigerator, includ-
ing the interior light.
If the refrigerator will not be in operation for a period of weeks,
it should be emptied, defrosted, cleaned and the doors left ajar.
The ice trays should also be dried and kept outside the cabinet.
ON
OFF AC GAS CHECK
AES
AUTO COLD 1 2 3 4 5 COLDEST CLC LAC
ON
OFF AC GAS CHECK
AES
AUTO COLD 1 2 3 4 5 COLDEST CLC LAC
The Low ambient control
switch is located beneath
the top decoration panel
that houses the control
panel.
The Climate control
switch is located beneath
the top decoration panel
that houses the control
panel.
staRtup
BURNER TUBE .
SPARK ELECTRODE
BURNER JET
BURNER MOUNTING
SCREWS
PRESSURE TEST PORT
MANUAL SHUT OFF VALVE
(Shown in open position)
INLET FITTING
SOLENOID VALVE
instructions for use
wARNINg
FIRe hAZARD. Before lighting the gas burner,
after that the Rv has not been used for some
time, please check that the gas path between
the burner jet and the burner tube has not been
obstructed. Failure to heed this warning could
cause a fire resulting in personal injury.
6
!