Dometic DM2862 - Manual (Page 8)

- 8 -
One screw installed in the rear base. 3.
NDR1292
Install the screws in the following order:
Two screws installed through the front base. 1.
(Installation of the lower front strip.)
The refrigerator is provided with a lower front strip
(shipped as a loose part). Attach the front strip after
the refrigerator is set into the cutout opening.
Install the a)
lower front
strip by slid-
ing it under
the bottom
hinge plate.
Secure the b)
refrigerator and
the lower front
strip with two
screws: One
screw through
each hinge.
Screws installed in the top frame. 2.
Open the doors and remove a)
the four screws that secure the
top decoration panel to the
top frame. Two screws are ac-
cessible from underneath and
two are located on each side of
the lock retainer securing the
decoration panel to the front frame. Save screws
for reinstallation of the top decoration panel.
See step 2, b-e in the previous instruction.
b)
Two screws installed in the rear base. 3.
RM2451, RM2454, RM2551, RM2554, DM2652,
DM2662, DM2663, DM2852, DM2862, DM3862 &
NDM1062
Install the screws in the following order:
Two screws installed through the front base. 1.
(Installation of the lower front strip.)
The refrigerator is provided with a lower front strip
(shipped as a loose part). Attach the front strip after
the refrigerator is set into the cutout opening.
Install the lower front strip by sliding it under the a)
bottom hinge plate. The hinge plate can be on the
right or left side depending on the door swing.
Once the lower front strip is slipped under the
hinge, the part is possible to swing into place.
Secure the refrigerator and the lower front strip
b)
with two screws: One screw through the hinge and
on the opposite side and then, one screw through
the lower front strip.
Two screws installed in the top frame. 2.
Open the door. Gently push the a)
tabs out of the hole in the hinge
with a flat blade screwdriver
(both sides).
Carefully tilt the top decoration
b)
panel and lift to remove from
top frame. Be careful not to
damage the circuit board and wires.
Install the two screws in the top frame, the holes
c)
are accessible from underneath.
Seal the opening for the screws with aluminum
d)
tape.
Replace the top decoration panel. Be careful not
e)
to pinch the wires behind the panel. Make sure the
tabs snap back into the holes in the hinge plate.
installation procedure
2
1