Knox Video Media Flex Series User Manual

Page 6

Advertising
background image

SECTION 1. GENERAL INFORMATION

1.1 INTRODUCTION

The KNOX MEDIAFLEX SERIES AUDIO/VIDEO DISTRIBUTION SYSTEM

are modular devices which accept up to sixteen composite, Y/C, RGBHV, or analog
HDTV video sources (up to 1080I or 720P), sixteen unbalanced or balanced stereo
audio sources, and (optionally) eight sources of VGA signal. The MediaFlex con-
nects any one of the input SOURCES (buffered electrically) to one or more of the
sixteen ZONES.

1.2 TECHNICAL DESCRIPTION

The MediaFlex Series uses a single chip microprocessor with battery-backed

memory to drive a set of monolithic digital latching crosspoint decoders.

Cross-point information is collected by the microprocessor from the front

panel pushbutton switches, the infrared remote control, or from the RS232 input
on the rear panel, and distributed to the crosspoint decoders. Audio or video may
be routed together or separately.

1.3 DETAIL SPECIFICATIONS

Video Channels:

Levels:

1v NTSC or Y/C (S-VHS or Hi-8) or analog HDTV
(YUV or RGB)

Frequency Response:

DC to 30MHz
@ 1v <3dB down at 30MHz

Input Impedance:

75 ohms

Output Impedance:

75 ohms

Crosstalk:

less than -70dB@5MHz

Audio Channels:

Levels:

Unbalanced audio:

2v p-p unbalanced audio

Balanced audio:

up 16dBM

Frequency Response:

20Hz through 30KHz

KNOX VIDEO

MediaFlex Series Audio/Video Distribution System

Page 1

Limited Warranty

Unless otherwise stated in the product specific documentation received

with this product, Knox Video Technologies provides a five-year limited
warranty for this product. The above warranty period shall begin on the
date of shipment by Knox to purchaser or, if purchaser is an authorized
reseller of such Knox products, from the date of shipment by the reseller to
the reseller’s original customer.

The warranty set forth above shall not apply to failure or deficiency

which has been caused by misuse, abnormal or unusually heavy use, neglect,
alteration, improper installation, unauthorized repair or modification, improper
testing, accidental or causes external to the product such as but not limited
to excessive heat or humidity, power failure, or improper installation.

IF SERVICE IS REQUIRED:

If the product does not perform as warranted, call Knox Video Technologies
at 301-840-5805 for available service options.

If it is necessary to return an item to Knox, the defective product should be
securely packaged in original boxes and insured for shipment. Owner agrees
to insure and accept all liability for loss of or damage to this product.

YOU MUST CALL TECHNICAL SUPPORT AT 301-840-5805 FOR
A RETURN AUTHORIZATION NUMBER (RA) AND “SHIP-TO”
ADDRESS BEFORE SHIPPING ANY PRODUCT TO KNOX.

This warranty gives you specific legal rights, and you may also have other
rights, which vary from state to state.

Knox Video Technologies

8547 Grovemont Circle

Gaithersburg, MD 20877

301-840-5805 / 301-840-2946 Fax

www.knoxvideo.com

Advertising