Operation – Monroe Electronics R190A User Manual
Page 12
Advertising
Section 1 EAS
10
Operation
Testing the unit can be done by accessing the unit in the same manner it was
programmed. Enter the unit’s IP address into your browser and the following
display will be shown. Triggering any of the four relays can be done in either a
latching mode or Pulse. Clicking on the button, On, Off, or Pulse, on the desired
relay will allow you to test that the device being controlled by the R190A is
functioning properly. The color of the relay status will change from red to green
when the relay is closed.
Advertising