Monroe Electronics R190A User Manual
Page 21
Advertising
Section 2 Remote Control
19
OPERATION
Operating the unit can be done by accessing the unit in the same manner it was
programmed. Enter the unit’s IP address into your browser and the following
display will be shown. Enter any applicable passwords. Triggering any of the four
relays can be done in either a latching mode or Pulse. Clicking on the button, On,
Off, or Pulse, on the desired relay will allow you to operate the device being
controlled by the R190A. The color of the relay status will change from red to
green when the relay is closed.
Advertising