TelVue AdCaster - Manual (Page 9)

go to the next menu. On the next menu the subnet mask for the IP address
will be entered (figure 2.7). The display will pre-compute what it thinks the
subnet mask should be based on the current IP, but it may need to be adjusted
depending on the special configuration of the network it is being attached to.
Figure 2.7: Set the subnet mask.
Just like configuring the IP address, the subnet is configured in the same
way. Use the up and down arrows to change the value of the highlighted digit,
and the left and right arrows to select the digit to change. When the netmask
has been successfully entered, press the enter key to continue to the next menu.
The next menu will allow you to set the default gateway. This menu works
exactly the same as the previous two. Once you have entered the address of the
default gateway and pressed enter, the settings will take and you will be able
to access the web app.
Figure 2.8: Set the default gateway.
2.3 Using the web app
Once you have the network set up on eth0, you will be able to access the
AdCaster web application. This application is used for all tasks going forward.
When you first connect to the AdCaster you will be prompted for a user name
and password. The default login and password are given in figure 2.9.
It is recommended that you change this password especially if the AdCaster
has an Internet facing address.
8