AGI Security SYS-4HNVR304 Manual - Manual (Page 32)

MAIN MENU
26
5.4.3 DETECTION
ADVANCED CONFIG
CONNECTION CH1 CH2 CH3 CH4
CAMERA ALARM OFF
DETECTION SENSITIVITY 0
ALERT MOTION ON
NETWORK AREA EDIT
DISPLAY INTERNAL ALARM ON
RECORD
NOTIFY
EXIT
1) ALARM
Select N.C./ N.O depending on your installation need. The default alarm value is OFF.
2) SENSITIVITY
Select the detection sensitivity of the selected channel, the lower the value, the higher the sensitivity.
3) MOTION
Select if you want to activate the motion detection function for the selected channel (ON/OFF).
4) AREA
Click “EDIT” to set the motion detection area.
There are 16 × 12 grids per camera for all channels. Pink blocks represent the area that is not being detected
while the transparent blocks are the area under detection.
Note: To exit area setting and return to the detection page, right click your mouse.
5) INTERNAL ALARM (For selected camera models only)
This function appears only when the camera connected supports human detection.
Select “ON” to enable human detection, or “OFF” to disable it.
5.4.4 ALERT
ADVANCED CONFIG
CONNECTION EXT. ALERT ON
CAMERA INT. BUZZER OFF
DETECTION KEY BUZZER ON
ALERT VLOSS BUZZER ON
NETWORK MOTION BUZZER ON
DISPLAY ALARM BUZZER ON
RECORD HDD BUZZER ON
NOTIFY ALARM DURATION (SEC) 5 
HDD NEARLY FULL (GB) 5 
HDD OVERHEAT ALERT (°C) 60 
EXIT
1) EXT. ALERT
Select to enable or disable the sound when any external alarm is triggered (ON / OFF).
2) INT. BUZZER
Select to enable or disable the sound (ON / OFF) for all internal buzzers: KEY BUZZER, VLOSS BUZZER,
MOTION BUZZER, ALARM BUZZER, and HDD BUZZER.
Note: When this item is set to “OFF”, item 3) to item 7) will be disabled even though they are set to ON.
3) KEY BUZZER
Select to enable or disable the sound when pressing the buttons on the front panel (ON / OFF).