Avalon Firestyles 1250 Wood Stove - Manual (Page 37)

Optional Equipment 37
© Travis Industries 100-01178 4081029
Rear Blower Installation (Part # 99000138)
The rear blower improves heat transfer by pushing heated air through the convection channel. Operating
instructions are described in the section "Blower Operation".
Twist the wires together and feed
them through the convection chamber
and out of the slot on the rear of the
stove (either side).
b
c
d
e
f
a
Attach the wires from
the thermodisk to the
wires from the blower.
Attach the blower to the stove with the
three screws included with the blower.
Position the blower near the rear of the stove. Tuck all excess wire into the
blower box, making sure it does not contact any moving parts. Make sure when
installing the blower, these wires do not become loose.
3/8" Wrench
g
Plug the blower in. Do not route the power cord under or over the stove or in a
location where it may become damaged.
Ashlip
Wedge the snap disk directly
in front of the stiffener on the
left side.
Bend these legs on the snap
disk if it does not fit tightly
Snap Disk
Assembly
Remove all slack from the wire and
secure with the included wire clip.
Wire Clip
Snap Disk Wires
WARNING:
To prevent electrical shock,
the wires must be secured
so they do not contact the
firebox above the
convection channel.