Avery Dennison Monarch 9855 RFMP Quick Reference - Manual (Page 14)

14
4. Clean the platen roller when you see significant
adhesive build-up or a label is wrapped around the
platen roller. Use a dry, soft-bristle brush, such as a
toothbrush, to clean the
platen roller.
If the brush does not
remove all the adhesive,
use isopropyl alcohol on
the platen roller. Moisten
a cotton swab with
isopropyl alcohol and run
the cotton swab across
the platen roller.
Turn the platen roller with your finger to make sure
the platen roller is clean all the way around. After
cleaning, feed several inches of supply through
without printing to remove any remaining isopropyl
alcohol.
5. Rub the cotton swab moistened with isopropyl alcohol
across the peel bar and remove any build-up.
6. Moisten another cotton
swab with isopropyl
alcohol. Rub the cotton
swab across the
printhead and remove
any build-up. You may
need to use a printhead
CLEAN-STRIP if the
printhead is extremely
dirty or you see streaks
on the supply.
7. Rub the cotton swab
across the supply
sensor and die cut sensor and remove any build-up.
P l a te n R o ll e r
P ri n t h ea d
S u p p l y
S e n s or