Avery Dennison Monarch 9855 RFMP Quick Reference - Manual (Page 7)

7
11. Close the printhead by
pressing down on the
thumb well until you
hear it click into place.
12. Close the cover.
13. Press Feed/Cut several
times to feed at least
three labels/tags to
properly position the
supply and the ribbon.
Loading Labels for the Optional Peel Mode
Peel mode (on-demand) must be purchased separately. In
peel mode, the printer separates the backing paper from
the label. The next label is not printed until the completed
one is removed from the printer. Make sure the printer is
configured for on-demand mode and the correct supply
type is installed. The minimum feed length is 1.5 inches
for peel mode. Hold the leading edge of peeled labels
when printing labels longer than six inches. You must use
non-perforated supplies for peel mode. Follow the steps
for loading supplies from the previous section. Then,
follow these steps after you close the printhead.
1. Remove the labels from the first 10 inches of the
backing paper.
2. Press down on the exit cover tabs to open the exit
cover on the front of the printer.