Avery Dennison Monarch 9855 RFMP Quick Reference - Manual (Page 5)

5
5. Adjust the supply holder guides so the sides barely
touch the roll. Make sure the supply roll turns freely.
If you are using fan-fold supplies, place the
supply stack behind the printer, label side facing
up.
6. Push down on the supply lever to unlock the supply
guides.
7. Lay the label strip across the supply guide so that a
few inches extend past the front of the printer. Tuck
the supply under the nibs and in between the die cut
sensor. Do not feed supply between the supply roller
and deflector.
For fan-fold supplies, lay the label strip over the
supply holder and across the supply guide so that
a few inches extend past the front of the printer.
Tuck the supply under the nibs and in between the
die cut sensor.
S u p p l y
H o l d er
G u i d e s
S u p p l y L e ve r