Avery Dennison Monarch 9855 RFMP Quick Reference - Manual (Page 16)

16
C o m m o n E r r o r s
If the action does not resolve the problem, call Service.
Error Action
002 Name must be 1 to 8 characters inside quotes.
005 Supply width is invalid.
018 Code page selection defined in the field is invalid.
025 Data length is too long.
101 Format referenced by batch not in memory.
400 Invalid character following {.
403 Field separator was not found.
409 Delete unused formats or graphics from memory.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.
413 Check for a flow control problem.
611 Font, bar code, or density in the batch is invalid.
612 The batch data is missing or invalid.
613 Reference point off supply.
614 Field off supply or invalid character in packet.
703 Calibration error. Load the correct supply type.
704 Supply error. Press Escape/Clear. Load supply.
751 Supply error. Press Escape/Clear. Load supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Ribbon jam. Load ribbon.
755 Printhead is open. Close the printhead.
756 Load supplies.
757 Load supplies. Press Feed/Cut.
758 Check for a label jam or reload supplies.
763 Waiting to dispense label. Press Feed/Cut.
765 Less than 8 bad dots in format area. Press
Escape/Clear.
768 More than 8 bad dots in format area. Replace or
connect printhead.