Avery Dennison 9820 Addendum - Manual

TC9800AD3 Rev. AA 9/99

1999 Monarch Marking Systems, Inc. All rights reserved.
O P E R A T O R ' S A D D E N D U M
This addendum describes the software changes available in
release 6.5 (or greater) of the Monarch

9840

printer and
release 5.4 (or greater) of the Monarch

9820

, 9830

, and 9835

printers. This addendum contains information about
♦
using the new supply/feed length and the new supply width.
♦ using extended backfeed on printers with a knife.
♦
defining a new cut mode in the batch control field.
♦ defining a Data Matrix

bar code.
♦ samples for MaxiCode Modes 0, 1, 2, and 3.
♦
printing TrueType

Fonts.
♦
Using International characters sets/code pages.
For more information about using configuration packets,
bar code or text fields, refer to the optional Packet
Reference Manual available from our Web site or in a
printed version by ordering part number TC9800PM.
U s i n g t h e N e w S u p p l y / F e e d L e n g t h a n d S u p p l y W i d t h
For the 9820, 9830, and 9835 printers, the minimum supply length is 0.5
inches (12.7 mm), instead of 0.75 inches (19 mm). For the 9840 printer, the
minimum supply length is 0.32 inches (8 mm) and the minimum supply width
is 0.75 inches (19 mm) instead of 1.2 inches (30.5 mm).
When printing labels shorter than 0.75 inches on the
9840 printer, we recommend using a maximum print
speed of 4.0 inches per second (ips).
Make sure the values in the format header match the length and width of
your supply. Measure supply from left to right and top to bottom or from the
top of one black mark to the top of the next black mark.