Baby Lock Crown Jewel (Previous Model) (BLCJ18) Instruction and Reference Guide Addendum - Manual (Page 4)

C. Attaching the leaders with Velcro
1. The hook side of the Velcro will be put on the
take-up rail, the backing rail, and the quilt top
rail
a) There is no leader for the batting rail, so you
will not need Velcro for that fourth rail
b) Cut the Velcro to the length needed for each
rail
2. Prepare the leaders
a) If you are using a frame set up smaller than
the width of the leaders, cut the leaders to
match the width of the rails on your frame
b) Attach the Velcro strips along the top edge of
each leader on the wrong side
1- The Velcro loops are the strip that is soft
and fuzzy
3. Fold each leader in half and mark the center at
both the top edge and at the hem
a) If you have marked the center of the rail, and
marked the center of each leader, then it will
be easy to get all of your leaders centered on
the rails
4. If you are using the Start-Right cloth leaders,
attach the shortest width leader to the take-up
rail
a) Match the center of the leader to the center
of the rail
b) The right side of the leader faces the back of
the frame
c) The Baby Lock leaders are all the same
width, so it will not matter which of the
three leaders is attached to the take-up rail
5. If you are using the Start-Right cloth leaders,
attach the medium width leader to the backing
rail
a) Match the center of the leader to the center
of the rail
b) The printed or right side of the leader faces
the back of the frame
c) The Baby Lock leaders are all the same
width, so it will not matter which of the three
leaders is attached to the backing rail
c) Place the hook side of the Velcro on the rails
1- The hook side is the stiff hard feeling side
of the Velcro
2- Trim the Velcro so it does not interfere with
gears on the end of the rail for the ratchet
3- The easiest way to attach the Velcro is to
peel back about six inches of the paper and
press the sticky Velcro into place. Then
peel back the next six inches of paper and
press
Note: If you remove the paper from the entire length
of the sticky Velcro, you will end up with a big knot of
Velcro stuck to itself instead of the rails!
3