Baby Lock Crown Jewel (Previous Model) (BLCJ18) Instruction and Reference Guide Addendum - Manual (Page 5)

6. If you are using the Start-Right cloth leaders,
attach the widest leader to the quilt top rail
a) Match the center of the leader to the center
of the rail
b) The printed or right side of the leader faces
the back of the frame
c) The Baby Lock leaders are all the same width,
so it will not matter which of the three leaders
is attached to the quilt top rail
Note that all of the leaders face the back of the
frame and there is no leader for the batting rail 4. Pin the quilt top to the right side of the leader
a) Match the center of the quilt top edge to
the center mark on your leader
b) Long straight pins with flat heads are ideal
for this
1- Pins are parallel to the edge of the quilt
top, and placed about 1/4” apart
2- Pins can point either right or left,
however you may want to place the pins
on each end with the points toward the
center of the quilt top. This will keep
you from poking yourself with those
pins on the end as you work
A. The back of your quilt and the batting will need
to be cut larger than the quilt top
1. Always make the quilt back four to six inches
wider than your quilt top
2. The back of the quilt should also be at least six
inches longer than the quilt top
3. The batting should be at least two inches wider
than your quilt top
B. Attach the quilt top to the leader on the quilt
top rail
1. Roll the backing leader up so it is out of the way
2. Lay your quilt top over the top of the frame with
the right side up
3. Find the center of the quilt on the edge that will
be pinned to the leader and mark it with a pin
Step 3
Load the Quilt on the Frame
4