Bematech MP-4000 TH User's Manual - Manual (Page 17)

MP-4000 TH . Revision 1.3
17
Configuring
The printer is set up by factory default for most users. For those who need a special
configuration, the MP-4000 TH offers various settings. These options can be modified through
the Printer’s menu. Several settings can be changed in the Printer Menu.
The Printer Menu is self-explanatory. To enter the Printer Menu you have to switch off the
printer and switch on again with the FEED BUTTON ( ) pressed. When it starts to print you
can release the Feed button ( ).
…
- Wait to start Self-Test
- Press ‘FEED’ switch 1x for CONFIG MODE
- Press ‘FEED’ switch 2x for DUMP MODE
After printing the menu above:
Press the FEED BUTTON ( ) once and the Configuration of the Printer will be printed.
Press the Feed button ( ) twice to enter the Configuration Mode.
Press the Cut button ( ) to go to the next parameter or wait to exit Configuration Mode.
Configuration Mode
This mode offers the possibility to change the language, printer density, configuration of Near
End Paper Sensor, paper width, Command Set and Print Mode.
(¹) The "Paper Width” can be altered only if the "Command Set " is configured as "BEMATECH."
To enter the Printer Menu you have to switch off the printer and switch on again with the FEED
BUTTON ( ) pressed. Wait until that the menu is printed release and press the FEED BUTTON
( ) again.
Choose the next parameter by pressing the Cut button ( ), modify the parameter with
the Feed button ( ) and observe the result. To accept the change in the parameter press the
Cut button; it will automatically move to the next parameter in the list.
The printer will guide you through the options by printing a response after every decision you
make.
To jump back you have to restart the Configuration Mode and go through the list of
parameters.
22. Language Configuration
In this section, you can configure the language that the Printer Menus will present to you.
You can configure to English, Spanish or Portuguese.
The factory default setting is English.