Bematech MP-4000 TH User's Manual User Manual
Page 19
MP-4000 TH . Revision 1.3
19
25.1.
Adjusting the Paper Width
To adjust the paper width simply pull the spacer up and insert it in the desired position,
according to the paper width desired. The figure below helps to identify the correct position, in
compliance with the paper width. Note that for 82.5 mm paper width the spacer is not used at
all. Keep it stored if in the future you will need to change back to a different paper width.
26.
Command Set Configuration
In this section you can configure the command set that the printer will recognize when
receiving printer commands from the host system.
You can configure to Bematech or ESC/POS
TM
.
27.
Print Mode Configuration
In this section you can configure the Print Mode according to your needs.
You can configure to High Quality or High Speed.
The factory default setting is High Speed.