Beurer HLE 60 - Manual (Page 12)

12
• When used on wet skin, it is important that the skin is sufficiently damp so that the device can glide
optimally over the skin. Epilating is easiest after a shower or bath.
• Do not use any cream before epilating.
• Epilation is easier and more comfortable if the hairs are at the optimal length of 2-5 mm.
If the hairs are longer, we recommend that you first shave the area and after 1-2 weeks epilate the
shorter regrowth.
• Thoroughly clean the epilator attachment before epilating. This reduces the risk of infection as much as
possible.
• Press the on/off button to switch on the device.
• Press the button again to increase the speed.
• The “Epilight” function ensures optimal lighting conditions so that you can see and remove even the fi-
nest hairs.
• Hold the skin taught with your free hand to help lift the hairs.
• Move the device slowly, steadily and without pressure over the skin, with the “Epilight” side pointed
against the direction of hair growth. Make sure you hold the device vertically at a 90° angle to the skin.
As hair doesn‘t always grow in one direction, it can be useful to move the device in various directions
over the skin to achieve an optimal result.
• Be aware that the underarm and bikini areas may be particularly sensitive to pain at first. We therefo-
re recommend that you use the lowest speed setting for the first use. The pain will lessen with repeated
use. As skin in this area is particularly sensitive after epilation, do not use any substances that might irri-
tate the skin such as alcohol-based deodorant.
changing the attachment:
• To replace an attachment, press the unlock button and take the epilator attachment off
the device.
• Place the corresponding attachment back on the device, ensuring that it clicks into
place.
• Can only be attached in one direction.
• To change the shaver or exfoliation attachment, remove the attachment from the
attachment holder and then reinsert the attachment you wish to use.
note
We recommend that you use the shaver attachment on the second speed setting to achieve optimum re-
sults.
5. care and storage
WarnInG
• Disconnect the device before cleaning it.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the
device or accessories.
• Clean the epilator, exfoliator and shaver attachment with the cleaning brush. We recommend
that you moisten this beforehand with alcohol to guarantee a hygienic clean. Brush the attachments
out from behind while you turn the roller by hand.
• Make sure that the relevant attachment is completely dry before you put in back on the device.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use aggressive cleaning agents or hard brushes.