Beurer BY 99 - Manual (Page 31)

31
9.4 General settings
In the general settings you can set the clock mode (12h / 24h) and temperature mode (°C/°F).
In addition, you can also activate the “Do not disturb” function.
1. When you see the current transmission image, tap the Beurer CareCam logo on the top left.
You are taken to the camera menu.
2. Now tap on “Settings” at the top.
3. To set the clock mode/temperature mode, tap the “General settings”.
4. To activate the “Do not disturb” function, first tap “Do not disturb” and then “ON” to the
right. Now set the required length of time (3 hours max.) by moving the point.
Note
When the “Do not disturb” function is activated, you will not receive push messages during
the period selected.
10. Operating the camera via the app
10.1 Switching on the camera
IMPORTANT
Only use the mains part plug included in delivery.
• Connect the small end of the “Baby” mains part plug to the camera.
• Connect the other end of the mains part plug to the socket.
• Slide the ON/OFF switch on the side to “ON”. The function light starts to glow blue. (Push
the ON/OFF switch downwards to switch off the camera.)
• Open the “Beurer CareCam” app on your smartphone/tablet or the web portal on your PC.
• Log into your account.
• When you have correctly set up your camera (see Chapter 7), the transmission image ap-
pears on the display.
10.2 Adding another camera
It is possible to connect up to 4 cameras with one user account:
• When you see the current transmission image, tap the Beurer CareCam logo on the top left.
You are taken to the camera menu.
• Now tap “Add camera” on the bottom left.
• Follow the instructions in the app. As soon as you have successfully logged in, the transmis-
sion image of the attached camera appears automatically.
10.3 Removing a camera
To remove a camera from your user account again, proceed as follows:
• Tap the settings symbol ( ) in the camera menu of the camera you wish to remove.
• Tap on “Camera details”.
• Tap “Remove camera” and confirm.