Bluelab pH Controller Connect Manual - Manual (Page 6)

English
6
6.0 Connect the Bluelab Temperature Probe
Insert the temperature probe connector to
the base of the pH controller connect where
‘ATC’ is labelled. Ensure the connector is fully
inserted.
4.0 Installing the pH controller connect
Select a suitable location that is:
• Less than 5.65 feet / 2 meters from your reservoir.
The probes must be immersed in solution at all times.
• Less than 4.9 feet / 1.5 meters from an electrical
mains outlet.
• Less than 5.56 feet / 2 meters from pH Up or Down
solution. The inlet tube must reach the bottom of the
container.
• At a suitable height to see the display and for easy
operation (recommend slightly below eye level
when standing).
NOTE: Avoid placing the pH controller connect where
it can be damaged by direct sunlight, water, nutrient
salts or pH adjuster.
Fix the fasteners through the desired mounting holes in
the top and bottom of the case.
Mounting holes at top
Mounting holes at bottom
1
2
5.0 Connect the Bluelab pH Probe
Connect the pH probe to the pH controller
connect by lining up the lugs of the BNC
fi ttings.
Fasten securely by pushing the pH probe
connector on and twisting one quarter turn.
1
2
3.0 Set up the Bluelab Connect Soft ware
Note the 4 character KEY CODE on the rear of the Bluelab
pH Controller Connect.
Follow instructions in the Bluelab Connect Stick ‘Getting
Started’ guide to install the connect stick and connect
software. Add the pH controller connect to the software.
1
2
Inserting Twisting Attached
7.0 SAFETY - Handling pH up and down solutions
Bluelab pH Up or pH Down Solutions are available
in North America. They can be used undiluted
with the pH controller connect. Always follow the
manufacturer’s instructions for use and handling.
CAUTION: Wear eye protection and gloves when handling
this product. Harmful if swallowed. Keep out of the reach
of children. Store under cool and dry conditions. Not for
food, drug or household use. Read MSDS before use.
1
1
temperature probe connection