Manutenzione maintenance – Bompani BODPxxx User Manual

Page 24

Advertising
background image

24

524

I

GB

E’ consigliabile effettuare periodicamente la pulizia del frigorifero:

a)

esterno: con un panno inumidito in una soluzione di acqua tiepida e sapone liqui-

do e risciacquare con acqua pulita;

b)

interno: togliere la spina dalla presa di corrente attendere lo sbrinamento dell’ap-

posito scomparto; cella, griglie, ripiani, possono essere puliti con acqua tiepida e

bicarbonato di soda, sciacquati con acqua e asciugati; non usare detersivi abra-

sivi e fare attenzione a che non entri acqua nella scatola termostato. Nella parte

posteriore della scatola termostato b posta la lampada di illuminazione interna.

In caso di prolungate assenze è consigliabile arrestare il funzionamento del frigorifero

e tenere aperta la porta per evitare la formazione di muffe o di cattivi odori.

Il frigocongelatore non ha bisogno di nessun tipo di manutenzione salvo la sostituzio-
ne della lampada interna.
ASSISTENZA TECNICA
P

Prima di chiedere l’intervento del Servizio Assistenza Tecnica se il frigorifero e inattivo

verificare che la spina di alimentazione sia ben inserita nella presa e che il termostato

It is advisable to periodically clean the refrigerator

a) outside, with a cloth dipped in a tepid solution of water and liquid soap and

then rinse with clean water;

b) inside; disconnect the appliance and wait for complete defrosting; wipe grids,

shelves and liner with a cloth dipped in a tepid solution of water and sodium
bicarbonate of soda: rinse with clean water and dry. Never use abrasive deter-

gent sand take care that water does not go inside the thermostat box.

The internal light bulb is located in the back section of the thermostat box.
In case of prolonged absences, you should turn off the refrigerator and keep the door

open to avoid the formation of mould and unpleasant smells.
ASSISTENZA TECNICA
Before calling your local authorized agent if the refrigerator is not working check that

the plug is properly inserted into the electric socket and that the thermostat is not set on

position “0”; if the refrigerator is abnormally noisy, make sure it is perfectly levelled and

that no external object is touching the back panel of the appliance; if the refrigerator

MANUTENZIONE

MAINTENANCE

non sia in posizione “0”; se il frigorifero e rumoroso controllare il livellamento e verifi-

care che non vi sia qualche oggetto esterno a contatto con la parete posteriore; se il

frigorifero ha una resa insufficiente controllare che l’interno non sia troppo stipato, che

la i porta sia chiusa ermeticamente e che il condensatore non sia pieno di polvere.Se

notate eccessiva presenza d’acqua nella parte inferiore del frigorifero (verduriera e

piano estraibile) controllare che il foro di scarico dell’acqua di sbrinamento non sia

otturato. L’ installazione e a carico dell’acquirente; non rispondiamo dei danni causati

da errata installazione e decliniamo ogni responsabilità nel caso in cui il collegamento

di messa a terra non sia realizzato secondo le vigenti norme nazionali.

Al termine della vita funzionale dell’apparecchio che utilizza gas refrigerante R 600a

(isobutano) e gas infiammabile nella schiuma Isolante, lo stesso dovrà essere messo
in sicurezza prima dell’invio in discarica. Per questa operazione rivolgersi Vs. nego-
ziante e all’ente Locale preposto.

ATTENZIONE: Non danneggiare il circuito di refrigerazione.

does not produce enough cold, check that it has not been over loaded, that the door

closes properly and that the condenser is not full of dust If you should notice an excess

amount of water in the lower part of the refrigerator | (vegetable box and removable

shelf), | check that the drain hole for defrost water is not clogged.
The buyer is responsible for damages caused by faulty installation, and not responsibil-

ity can be accepted if the appliance is not earthed in accordance with the national

standards rules presently in force.

At the end of the functional life of the equipment which uses cooling gas R600a

(isobutane) and inflammable gas inside the insulating foam, it must be placed in
safety before sending it to the waste disposal. For this operation contact your dealer
and the local authorities.

WARNING: Do not damage the refrigerant circuit.

Advertising