Bronkhorst CORI-FLOW - Manual (Page 20)

BRONKHORST CORI-TECH B.V.
For meters only the output signal is available.
At analog operation the following parameters are available:
- measured value
- setpoint (controllers only)
- valve voltage (controllers only)
Note:
When operating the instrument through the analog interface it is possible to connect the instrument to any
supported fieldbus system (or RS232-interface with special cable) for reading/changing parameters (e.g.
controller response or other fluid selection).
For FLOW-BUS versions of the instruments a readout/control module for digital instruments can be
temporarily connected to the M12 Connector.
mA
- +
instrument
output
0V common
power
supply
instrument
output
I
Sinking Sourcing
Current output signals
I
mA
+
-
0V common
page 20 9.17.031