BUG-O Systems MDS-1004 - Manual (Page 5)

5
INTRODUCTION
The MDS-1004 PROGRAMMABLE MODULE provides stitch controls for welding or cutting
with the Modular Drive System. The graphic display interface allows the user to view the exact
value of each stitch parameter for precise and repeatable configuration. The Programmable Module
contains an extra weld contactor output which can be enabled or disabled independent of the
Modular Drive Unit contactor.
FEATURES
• Exact, repeatable stitch configuration. Each stitch parameter is displayed while being set;
allowing each parameter to be exactly set each time a job is set up.
• Two contactor outputs. Programmable Module includes a 2-pin contactor output which can
be enabled or disabled independent of the Modular Drive Unit contactor.
• User defined home position. Module can be configured to return the machine to a position
before the weld start location for work piece change-out without gun interference. One button
will start the whole welding program again.
• No external limit switches. User defines whether module will stop the machine or return it to
the home position upon completion of the last weld of the program.
• Resume mode. Stitch welds stopped mid-job can be restarted without interrupting the weld
pattern.
• Independent timers for Puddle-buildup and Crater-fill.
• Closed loop feedback ensures the traveled distances match the set distances.
Display
Controls
2-Pin Contactor Output