Campomatic WM80LS - Manual (Page 13)

If you are not sure whether the washing machine is grounded
accurately, check and verification should be performed by service
agent or qualified person.
If the power cord is damaged, replacement should be conducted by the
product and service agent or qualified person to avoid risk. The plug
attached to the washing machine cannot be transformed. If the plug
cannot match the socket, a suited one should be installed by
theproduct and service agent or qualified person.
The working water pressure of the washing machine is 50KPa~800KPa.
When the water pressure is below 50KPa, the water supply valve may
not work normally, or the time of water supply is longer than that of
program control, and the display screen shows “SF”.
To make the most of the washing machine, position it on a hard, level
and clean surface without any water or oil. If the surface is uneven or
not clean, noise or vibration may occur.
Before using the washing machine, first check all connections of the
water supply valve and water faucet to prevent water leakage.
The water supply faucet must be less than 122cm away from the rear of the washing
machine so that the water supply hose can be easily connected to the washing
machine and the water faucet.
To prevent the risk of water leakage and waterway damage, consider the following
ways:
◆ The washing machine shall be close to the water faucet.
◆ Turn off the water faucet when the washing machine is not used.
◆ Check water leakage conditions of the internal loop regularly.
Service Instructions
Power supply and grounding
Water Supply
Installation environment requirements
Ground location