Campomatic WM80LS - Manual (Page 30)

Service Instructions
Cleaning the water supply valve filter
Cleaning the debris filter
1. Pull out the power plug and turn off the water supply faucet of the washing
machine.
2. Unscrew the water supply hose from the back of the machine.
3. With a pair of pliers, gently pull out the water supply valve filter from the
valve connector and rinse it under water until clean. Also clean the inside and
outside of the threaded connector.
4. Push the filter back into the original place.
5. Reconnect the water supply hose.
6. Turn on the faucet and make sure the connections are watertight.
Don’t unscrew the debris filter when the machine is in operation or
when hot water is flowing out.
◆ Make sure the filter is replaced into the machine when the cleaning is finished.
Otherwise, fault or water leakage may occur.
◆ Make sure the filter is assembled in place.
4. Replace the debris filter in situ.
5. Install the debris filter by rotating right and replace the bottom baffle.
④ ⑤
You should clean the supply valve filter at least 3 to 4 times per year,
or when you see “SF” error message on the display: