Campomatic WM80LS - Manual (Page 17)

Connecting the water supply hose
Service Instructions
Connection and installtion methods are as follows:
1. Connect the L-shaped mounting arm for the cold water supply hose
to the cold water supply valve on the back of the washing machine.
Tighten by hand.
The water supply hose must be connected to the washing machine at one
end and to the water tap at the other. Do not stretch the water supply hose.
If the hose is too short,replace the hose with a longer, high pressure hose.
2. Connect the other end of the cold water supply hose to your sink’s
water faucet and tighten it by hand. Use the special faucet of the
washing machine.
Turn on the water faucet and check if there is water leakage at the joint of the
water supply hose before positioning and using this appliance.
If there is water leakage, repeat the steps aforesaid.