Campomatic WM80LS - Manual (Page 18)

Positioning the drain hose
Plugging in the washing machine
Service Instructions
The end of the drain hose may be positioned in three ways:
Plug the power cord into a wall socket which must be a qualified AC
220V/50Hz socket protected by a fuse or a circuit breaker.
After completing the installation of the washing machine, run the “Rinse +
Spin” program to ensure proper installation.
1.In a floor drain directly
We recommends that you shall use the drain hose attached to the
appliance; it can be directly inserted into the floor drain with the width
of the trough entry not less than 4 cm.
2.In a sink drain hose branch:
The end of the drain hose is connected to a sink drain hose branch. If
the hose is too long, it cannot be forced into the washing machine,
otherwise abnormal noise may occur. Note: the width of the sink entry
shall not less than 4 cm.
3. Over the edge of a wash basin:
The end of the drain hose must be placed at a height of between 60 and
90 cm from the ground. To avoid the influence of the drain hose
bending on water flow, secure it over the edge of the wash basin with a
hook or a piece of string to prevent the drain hose from moving.
Note: the end of the drain hose cannot be immersed in water.
Test run
Min. 4cm
Min. 60cm
Max. 90cm
Max. 90cm