Coda Audio C5 - Manual (Page 11)

11
Using unbalanced connections
When connecting the C5 amplifier to an unbalanced audio source, the signal conductor
should be terminated to XLR pin2 and the cable screen terminated to both pins 1 and 3.
In bridged mode output channel 1 signal chain provides the signal for the 1 & 2 pair of
amplifier channels, output channel 3 signal chain provides the signal for the 3 & 4 pair.
Amplifier output connections
The C5 amplifier is fitted with one Speakon
TM
connector per amplifier channel. The
appropriate conductor terminations are shown below and on the rear panel of the unit.
The Speakon TM connector for amplifier channel 1 carries the output for amplifier channels
1 and 2. In addition this connector can also be used if the pair of amplifier channels is
being operated in bridged mode.