Coda Audio C5 - Manual (Page 13)

13
Front Panel
Power Switch
The C5 amplifier is fitted with either one or two dual channel power modules. As the
power modules operate independently there is a separate power switch for each. When
the power switch is operated, the protect indicator will flash while the DSP and amplifier
control systems are prepared. After approximately 3-4 seconds the amplifier will be
operational and the audio level is gradually ramped up.
Power ON indicator
Each Power Switch is associated with a POWER indicator. This green indicator is lit when
power is applied and the power switch is in the ON position.
Bridged Mode indicator
It is possible to use the dual channel power modules in Bridged Mode. This is enabled
using the C-Net PC control application. Further details on Bridge Mode can be found in the
C-Net control section of this user mode.
Control Software Online indicator
A network of C-Net compatible products including the C5 range of DSP amplifiers can be
controlled, configured and monitored using the C-Net PC application. The Online indicator
will light when the amplifier is correctly connected to C-Net.