Vfs feature configuration, Vipersat modem configuration, Vfs feature configuration -9 – Comtech EF Data VIPERSAT File Streamer v1.2.x User Manual
Page 27: Vipersat modem configuration -9, Figure 2-12 feature configuration, cdm-570l 2-9
Chapter
2 -
VFS Installation
2-9
VFS Feature Configuration
VFS Feature Configuration
In order for the VFS software application to successfully perform a file transfer,
the Vipersat satellite modems serving as VFS gateways and the VMS must be
configured appropriately.
Vipersat Modem Configuration
Using either the Parameter Editor (VMS or Vload) or the modem CLI, config-
ure the VFS Gateway Modems as follows:
• Enable Automatic Switching on each modem (see example below).
• Enable the Vipersat File Stream feature on each modem.
This involves two requirements:
one, the VFS Feature Code, an optional feature that must be purchased
for each Vipersat modem, must reside on the unit;
two, the Vipersat File Stream feature must be enabled, as shown in the
example below.
Figure 2-12 Feature Configuration, CDM-570L