D.T. Systems Micro-iDT Z3000 (ex. serial #A12345) User Manual
Page 12
12
Electrodes
Electrodes should fit snugly on the dog’s neck to
ensure good contact with the skin. For more
information on the proper fit of the collar, see page 7.
Collar Belt with Embedded Receiver Antenna
The embedded collar antenna is woven into the collar
belt, and runs the along the entire length of the belt.
Battery Charging Receptacle
The battery charging receptacle is located on the side
of the Collar Unit. After charging, always close the
jack with the rubber plug to prevent foreign particles
from getting inside the unit.
Red Mark on the Collar Unit
The Red Mark indicates the location of the
Magnet Switch in the receiver. To turn the
receiver ON/OFF, touch and hold the Red
Mark with the Magnet Indicator (Red
Mark) on the side of the transmitter until the LED light
on the Collar unit starts to flash.
PARTS & FUNCTIONS CONT.
WARNING
Do not cut the collar belt.
Doing so will damage the antenna and may result in
severely decreased receiver range.