D.T. Systems Micro-iDT Z3000 (ex. serial #A12345) - Manual (Page 16)

16
REPROGRAMMING
If you own a multiple dog unit, you must select the
collar that is being programmed on the Collar
Selecting Switch before starting this procedure.
1. Hold the Red Mark (Magnet Indicator) on the left
side of the Transmitter directly against the Red Mark
(Magnetic Switch Indicator) on the front of the Collar
Receiver.
2. A small red light inside the Collar Receiver will
light up solid for about 1 second, followed by 6
flashes. You must keep the Transmitter next to the
Collar Receiver during this time.
3. Continue to hold the Transmitter against the Collar
Receiver until the LED light stays on solid. The Collar
Receiver is now in the Code Running Mode (the LED
light will stay lit for approximately 8 seconds while it
is in this mode).
4. Remove the Transmitter from the Collar Receiver
and press the NICK and CONT buttons simultaneously
while it is in the Code Running Mode.
5. When the LED light blinks 3 times, the Collar ID is
now programmed and the Collar Receiver is now ON.
NOTE – Do not remove the Red Mark on the
Transmitter from the Red Mark on the Collar Receiver
until after the LED light has flashed 6 times, or the
Collar Receiver will not go into the Code Running
Mode. You must press the NICK and CONT buttons
simultaneously while the LED light is lit solid.