Daktronics DMP-1500/M3 (SS & ST) Setup With Show Control User Manual
Page 9
DMP-1500/M3 (SS & ST) Setup With Show Control Quick Guide
9 of 11
201 Daktronics Drive PO Box 5128, Brookings, SD 57006
Tel: 1-800-325-8766 or 605-697-4300 Fax: 605-697-4746
Website: www.daktronics.com
DD1805670 Rev 11
2 July 2012
8.
Click the Active Files button on the left-hand side of the window.
9.
Right-click in the area that says No items to display, and then select
Insert File.
10.
In the Insert Active File window:
Put a checkmark in the box next to Port 2.
Click the […] button and browse to “C:\Program Files
(x86)\Daktronics\DCS\Scripts\Custom” and select
“OffsetStandardRTD5000.dds”
Click OK when finished.
When data is sent from Hy-tek, it should now go out to the display. If
there is more than one Ethernet connection configured on the computer,
for example one wireless and one wired, you may need to disable the
unused network, or change the order of preference to ensure that the
information is delivered to the desired network.
A second possibility is to direct the data to a specific display address
when configuring the UDP/IP Output Port:
Note: To ensure that DCS recognizes each COM port, try to have
all USB-to-serial adapters connected before the computer is
turned on. If DCS did not recognize a COM port (evident by
going to the Ports screen in DCS and seeing a red indicator next
to the Serial Port): go back to the Control screen, click Stop,
count to ten, and then click Start.
Port 3 and Port 4 can be configured to receive data from another
source, for example a FinishLynx Capture station with a dedicated
results output, or a FinishLynx Edit station. On the Insert Active File
window (see previous page), the “OffsetStandardRTD10000.dds”
and “OffsetStandardRTD15000.dds” files would need to be set to
Port 3 and Port 4, respectively.
For more information on setting up track interfaces, refer to the
Track and Field Interfaces Setup Guide (ED14511), available online
a