DFI CR960-HM76 - Manual (Page 29)

www.dfi .com Chapter 3 Hardware Installation
29
Chapter 3
Standby Power LED
Standby
Power LED
This LED will light when the system is in the standby mode.
Cooling Option
Heat Spreader with Heat Sink and Fan
• “1” and “2” denote the locations of the thermal pads
designed to contact the corresponding components that
are on CR960-QM77/HM76.
Top View of the Heat Sink
Bottom View of the Heat Sink
Important:
Remove the plastic covering from the thermal pads prior to mounting the heat sink
onto CR960-QM77/HM76.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
1
2