DFI CR960-HM76 - Manual (Page 41)

www.dfi .com Chapter 4 BIOS Setup
41
Chapter 4
Device reset time-out
Select the USB mass storage device start unit command time-out.
Device power-up delay
The device will take maximum time before it properly reports itself to the Host
Controller. “Auto” uses default value: for a Root port, it is 100 ms; for a Hub port, the
delay is taken from Hub descriptor.
Network Stack
This section is used to enable or disable UEFI Network Stack.
Enable/disable UEFI
network stack.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Network Stack
Advanced
[Disable Link]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit