DFI CR960-HM76 - Manual (Page 36)

www.dfi .com Chapter 4 BIOS Setup
36
Chapter 4
CPU Configuration
This section is used to configure the CPU. It will also display the detection of CPU information.
Limit CPUID Maximum
The CPUID instruction of some newer CPUs will return a value greater than 3. The
default is Disabled because this problem does not exist in the Windows series
operating systems. If you are using an operating system other than Windows, this
problem may occur. To avoid this problem, enable this field to limit the return value to
3 or less than 3 .
Intel Virtualization Technology
When this field is set to Enabled, the VMM can utilize the additional hardware
capabilities provided by the Intel Virtualization technology. A full reset is required to
change the setting.
Disabled for Windows XP.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Advanced
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit
CPU Confi guration
Intel(R) Celeron(R) CPU 827E @1.40GHz
CPU Signature
Microcode Patch
Max CPU Speed
Min CPU Speed
CPU Speed
Processor Cores
Intel HT Technology
Intel VT-X Technology
Intel SMX Technology
64-bit
L1 Data Cache
L1 Code Cache
L2 Cache
L3 Cache
Limit CPUID Maximum
Intel Virtualization Technology
206a7
25
1400 MHz
800 MHz
1400 MHz
1
Not Supported
Supported
Not Supported
Supported
32 KB x 1
32 KB x 1
256 KB x 1
1536 KB
[Disabled]
[Diaabled]
SATA Configuration
This section is used to configure the settings of SATA device.
Enable or disable SATA
Device.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
SATA Controller(s)
SATA Mode Selection
SATA Test Mode
Serial ATA Port 0
Software Preserve
Serial ATA Port 1
Software Preserve
Serial ATA Port 2
Software Preserve
Serial ATA Port 3
Software Preserve
Advanced
SATA Controller(s)
This field is used to enable or disable the Serial ATA device.
SATA Mode Selection
The mode selection determines how the SATA controller(s) operates.
IDE Mode
This option configures the Serial ATA drives as Parallel ATA storage devices.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller
Interface).
RAID Mode
This option allows the Serial ATA devices to use RAID 0/1/5/10/Recovery (Redundant
Array of Independent Disks).
SATA Test Mode
This field is used to enable or disable the Serial ATA Test Mode.
[Enabled]
[IDE]
[Disabled]
ST500DM002-1BD (500.1)
SUPPORTED
Empty
Unknown
ATAPI iHOS10 ATAPI
N/A
Empty
Unknown
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
ESC: Exit