DFI HM961-HM86 - Manual (Page 36)

www.dfi .com Chapter 4 BIOS Setup
36
Chapter 4
ACPI Settings
This section is used to configure the ACPI settings.
ACPI Sleep State
Select the highest ACPI sleep state that the system will enter when the Suspend
button is pressed.
S3(STR) Enable the Suspend to RAM function.
Resume by PME
Enable this field to use the PME signal to wake up the system (via PCI, PCIE and
onboard LAN).
Resume by RTC Alarm
When Enabled, the system uses the RTC alarm to generate a wakeup event.
Select ACPI sleep state
the system will enter when
the SUSPEND button is
pressed.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
ACPI Settings
ACPI Sleep State
Resume by PME
Resume by RTC Alarm
Advanced
[S3 only (Suspend to...]
[Disabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
PC Health Status
This section displays the hardware health monitor.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
System Hardware Monitor
EC Version
CPU Smart Fan
CPU Temperature
CPU FAN Speed
VCore
DDR
1V05
Advanced
2014.03.04 v1.2
[Enabled]
: +30 C
: 3878 RPM
: +1.730 V
: +1.346 V
: +1.049 V
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Enable/ Disable CPU
SmartFan
CPU Smart Fan
Enable or disable the CPU smart fan.