DFI HM961-HM86 - Manual (Page 41)

www.dfi .com Chapter 4 BIOS Setup
41
Chapter 4
Device reset time-out
Select the command timeout for the USB mass storage device to start.
Device power-up delay
Maximum time the device will take before it properly reports itself to the Host
Controller. “Auto” is the default value: for a Root port it is 100 ms, for a Hub port the
delay is taken from Hub descriptor.
PCH-FW Configuration
This section is used to configure parameters of the Management Engine Technology.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
ME FW Version
ME Firmware Mode
ME Firmware Type
ME Firmware SKU
 Firmware Update Confi guration
Advanced
9.0.10.1372
Normal Mode
Full Sku Firmware
5MB
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Confi gure Management
Engine Technology
Parameters.
Firmware Update Configuration
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
ME FW Image Re-Flash
Advanced
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save and Reset
ESC: Exit
Enable/Disable Me FW
Image Re-Flash function.