Chapter 2 – DFI Q7-100 User Manual
Page 26
www.dfi.com
Chapter 2 Hardware Installation
26
Chapter 2
The 1-channel I
2
C bus interface conforms to the version 2.1 I
2
C bus specification. It operates
as a master or slave device and supports a multi-master bus.
I
2
C Connector
1
4
I
2
C_DAT
3V3
3 2
I
2
C_CLK
Ground
Can-bus Connector
The CAN controller performs communication in accordance with the BOSCH CAN Protocol Ver-
sion 2.0B Active1 (standard format and extended format). The bit rate can be programmed to
a maximum of 1Mbit/s. To connect the CAN controller module to the CAN bus, it is necessary
to add transceiver hardware.
When communicating in a CAN network, individual message objects are configured. The mes-
sage objects and the identifier masks for the receive filter for the received messages are
stored in the message RAM.
Controller Area Network (CAN or CAN-bus) is a message based protocol designed specifically
for automotive applications but now is also used in other areas such as industrial automation
and medical equipment.
4
1
2
3
NC
CANH
Ground
CANL