DFI Q7-100 - Manual (Page 6)

www.dfi .com Chapter 1 Introduction
6
IO Connectors • 2 connectors for 4 external USB 2.0/1.1 ports
• 1 LPC connector
• 1 I 2 C connector
• 1 CAN-bus connector
• 1 LVDS LCD panel connector
- 18/24-bit single channel
• 1 LCD/inverter power connector
• 1 8-bit Digital I/O connector
• 1 front audio connector for line-out and mic-in jacks
• 1 S/PDIF connector
• 2 Serial ATA connectors
• 1 24-pin ATX power connector
• 1 chassis intrusion connector
• 1 front panel connector
• 2 fan connectors
Expansion Slots • 1 PCIe x1 slot
• 1 Mini PCIe slot
- Supports half/full size Mini PCIe card
• 1 ExpressCard slot
Board to board
Connectors
• One MXM connector
Dimensions • Mini-ITX form factor
• 170mm (6.7”) x 170mm (6.7”)
Certifi cation • CE
• FCC Class B
• RoHS
Chapter 1 - Introduction
Specifications
Graphics • Chrontel CH7317B (SDVO to RGB DAC)
Audio • Realtek ALC886 5.1-channel High Defi nition Audio
• Audio outputs: Mic-in/Center+Subwoofer, line-in/surround
and line out
• S/PDIF audio interface
Storage • 2 SATA 3.0 ports with data transfer rate up to 6Gb/s
• 1 SD/MMC slot
LAN • 2 LAN ports
- LAN1: Gigabit Ethernet supported by the Qseven module
- LAN2: Realtek RTL8111DL PCIe Gigabit Ethernet controller
IO Chip • Winbond 83627DHG-P controller
• LPC interface
• Supports system fan
• Default I/O port address “2Eh”
Damage Free
Intelligence
• Monitors system temperature and overheat alarm
• Monitors system fan speed and failure alarm
Temperature • Operating: 0 o C to 60 o C
• Storage: -20 o C to 85 o C
Humidity • Operating: 10% to 90%
Rear Panel IO
Ports
• 2 DB-9 RS232 serial ports
• 1 DB-15 VGA port
• 1 DVI-I port (DVI-D signal)
• 2 RJ45 LAN ports
• 4 USB 2.0/1.1 ports
• Mic-in/Center+Subwoofer, line-in/surround and line out
Chapter 1